Olympus C-3000 - 3.2MP Digital Camera, Инструкция по эксплуатации

Страница: 222 / 236

222
TROUBLESHOOTING
OPERATING PROBLEMS
The camera does not work.
1
The power is OFF.
[
Set the Mode dial to turn on the power. (P. 36)
2
The batteries are loaded incorrectly.
[
Reload the batteries correctly. (P. 28)
3
The batteries are exhausted.
[
Replace the batteries with new ones. (P. 28)
4
The batteries are temporarily unable to function.
[
Keep the batteries warm while using the camera.
5
Power has shut off to conserve battery consumption.
[
Operate the shutter button or the zoom lever.
6
It is connected to a personal computer.
[
The camera will not operate while it is connected to a personal
computer.
No picture is taken when the Shutter release button is pressed.
1
The flash has not finished charging or the previous picture is being
written into the card.
[
Remove your finger from the Shutter release button and wait until
the Green lamp or the Orange lamp stops blinking. (P. 48/64)
2
There is a problem with the card.
[
See the Error code chart. (P. 227)
3
The card is full.
[
Replace the card, delete unwanted pictures or transfer the data to
a computer and delete all of the pictures. (P. 32/113/120/180 ~ 184)
4
The batteries ran out.
[
Replace the batteries with new ones. (P. 28)
5
The battery power is low.
[
Replace the batteries with new ones. (Do not open the Battery
compartment cover when the Card access lamp is blinking.)
(P. 28)
6
The buffer memory is full.
[
Wait until there is room in the buffer. (P. 51/129)
7
A write-protect adhesive seal is placed on the card or there is no card
in the camera.
[
Insert a new card in the camera. (P. 32)
8
The Mode dial is set to .
[
Set the Mode dial to P, A/S/M or . (P. 37)