the device’s back up operation and
emergency duration. This test is conducted
automatically every 6 months
.
In order to
be performed, the mains power supply and
the battery should be connected and fully
charged
.
If the battery is not fully charged
,
the test is postponed
until the battery is
completely charged. If during this test, the
autonomy is less than the nominal then the
battery fault led will turn on continuously
and the battery must be replaced.
Back Up Operation
The autonomous duration of battery during
emergency mode is at least the one that is
stated in the list of the technical
characteristics. During emergency mode, a
light source test is also performed.
Resetting Errors
Push the test button for >10 seconds to
delete all indicated errors. Then the
luminaire enters regular operation mode.
INSTALLATION
To
install
the
luminaire
follow
the
installation instructions on page 3.
ΑΤΤΕΝΤΙΟΝ
!!!
1. Operations for installation, maintainance
or testing must be done by authorized
personnel only
.
2.
The device must be connected to the
mains power supply through a fuse
dependent by the total amount of the line’s
power load
.
3.
In case of battery or lamp replacement,
these must be replaced by parts of the
same type, by the manufacturer or by a
competent person.
4. In case of inactive use for a period
greater than 2 months, disconnect the
battery by pulling out the battery’s
connector.
5
.
I
s not allowed to discard batteries
t i
into common trash bins, they must
be discarded only
in battery
recycling points. Do not incinerate.
The light source contained in this
luminaire shall only be replaced by
the manufacturer, or his agent, or a
similar qualified person.
NOTE! The light source is non-user
replaceable.
Connection to module
This luminary can be connected to any of
the following modules: Remote module,
address module and fault relay module. If
you connect it to a module that supports
inhibit or rest mode, you should know that
these commands can be cancelled only
during normal mode (ie. not in emergency).
You can also refer to the user manual of
each module for additional information. The
picture bellow shows the installation of the
optional module.
GREEN
RED
RED
Description
Battery charged no faults
Charging (battery test not possible while charging)
Mains off, battery not connected or charger fault
Battery test
Battery fault
Light source test
Light source fault
Battery fault and light source fault
Off
On
Flashing
Led status explanation
Indicator LEDs
Page 2 from
6
Picture 1
923064003_09_00
2
