background image

B30-006

EN

C000000

These instructions describe the correct operating method to ensure prolonged service life. Please read
and completely understand these instructions before operating your solar light.
Keep these instructions for future reference.

INTRODUCTION

Using LED (Light Emitting Diode) technology and powered by the sun, this solar light is ideal for
highlighting garden contours,pathways and driveways. During the day, the solar panel on top of the
light charge the battery inside. At dusk, the solar light will turn on automatically using the stored
energy from the sun.

The unique High /Low switch is designed to maximise brightness during summer, and maximise
operating time during winter and over extended cloudy periods.
When the switch is in the High position, the brightness can reach up to 60 lumens and will last up to
6 hours each night when the battery is fully charged.
In the Low position, the brightness can reach up to 30 lumens and up to 8 hours working time.

POSITIONING YOUR SOLAR LIGHT

*Your solar light includes a built-in photo sensor, which detects the level of surrounding natural light
and controls when the light will automatically switch on and off. Solar light should be placed away
from other night time light sources including other solar lights, as this might keep the light from
automatically turning on at dusk.
*

S

olar light must be located in an area where the solar panel will receive a maximum amount of full,

direct sunlight every day. Solar light should be exposed to at least 8 hours of direct sunlight each day
to fully charge the battery inside.
Shady locations will not allow the battery to charge fully and will reduce the hours of night time
light.

The performance of your solar light is dependent on your geographical location, weather
conditions and seasonal lighting availability. On cloudy days and during winter,your solar light

will not receive as much direct sunlight, resulting in reduced brightness and reduced operating

time.

ASSEMBLY
This pack should come with the following.

NB:Some components may come pr-assembled

Содержание B30-006

Страница 1: ... to 30 lumens and up to 8 hours working time POSITIONING YOUR SOLAR LIGHT Your solar light includes a built in photo sensor which detects the level of surrounding natural light and controls when the light will automatically switch on and off Solar light should be placed away from other night time light sources including other solar lights as this might keep the light from automatically turning on ...

Страница 2: ...r light head A 1 x pole piece with female thread B 2 x pole pieces with female male thread C 1 x pole piece with male thread D 1 x mounting base E 1 x ground stake F 3 x mounting screws G 3 x plastic anchors H ...

Страница 3: ...ounting base over the centre of the installed ground stake Step 4 To complete installation re attach the assembled solar light into the opening at the top of the mounting base HARD SURFACE INSTALLATION Step 1 Remove mounting base from the bottom of the assembled pole and gently place light down Step 2 Using a pencil place marks through the 3 holes located around the edge of the mounting base Step ...

Страница 4: ...orrectly Check to ensure that the battery is not loose and has been installed the correct way 4 Solar light might be positioned in a shaded location limiting its exposure to the sun and not allowing the battery to fully charge 5 Solar light might be too close to another night time light source including another solar light 6 Solar panel may be dirty limiting its exposure to the sun and not allowin...

Отзывы: