www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United Stateswith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
MS_SR_090418
Luminaires for High Abuse Applications
MILLENIUM
™
SQUARE
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH
ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT
TO AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS
AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE
FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
NL & CC INSTALLATION INSTRUCTIONS
SEMI-RECESSED SERIES
NOTE: This instruction sheet applies to wiring the
electrical tray provided for semi-recessed fixtures of
type NL (non-IC low profile) and CC (Closed Canopy)
mounting styles.
1. Disconnect power to the circuit before wiring
fixture(s).
2. Read all markings and labels to ensure correct
installation of fixture. Additional information may
be located on the fixture components, separate
from this instruction sheet, regarding orientation
and mounting restrictions.
3. Before installing electrical tray assembly, make
sure recessed housing (A) is clean, dry and free
of debris.
4. Unpack electrical tray assembly (C)
NOTE: Appearance of electrical tray will vary
depending on the model ordered.
5. Mount electrical tray assembly into recessed
housing using the three (3) supplied 10- 32 screws
(located in plastic bag). Use all screws provided.
6. Remove wireway cover (B).
7. Make electrical connections. Install in compliance
with the National Electrical Code, any applicable
local codes, and any specific instructions provided
on the luminaire labels. Supply wire must be rated
for 90°C minimum.
8. Replace wireway cover (B). Make sure all supply
wire connections are inside splice compartment.
