www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United Stateswith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
2
INSTALLATION INSTRUCTIONS
MS_SR_090418
9. Discard any screws installed in corner posts of
recessed sheet metal housing (A) (screws were
used to secure debris shield).
10. Remove lens or lens/eyelid assembly by loosening
the four (4) Torx
®
tamper-resistant screws. Screws
only need to be loosened enough to disengage
lens.
11. Prepare cast trim (B) for mounting to the recessed
sheet metal housing (A). For wet locations, caulk
backside of cast trim perimeter. This is necessary to
ensure wet location listing. Mount cast trim using
the four (4) 10-32 screws provided.
IMPORTANT: When wall mounting; attach cast trim
(B) so that reflector-mount brackets (D) are aligned
to correctly position the reflector (C) in relation to the
lamp socket.
12. Mount reflector assembly (C). Install lamp and lens
or lens/eyelid assembly. Tighten the four (4) lens
retention screws. Check that lens or lens/eyelid is
fully secure.
PP, ND & CO INSTALLATION INSTRUCTIONS
NOTE: This instruction sheet applies to wiring the
electrical tray provided for semi-recessed fixtures of
type PP (pour-in-place/masonry), ND (non-IC deep
profile) and CO (Open Canopy) mounting styles.
1. Disconnect power to the circuit before wiring
fixture(s).
2. Read all markings and labels to ensure correct
installation of fixture. Additional information may
be located on the fixture components, separate
from this instruction sheet, regarding orientation
and mounting restrictions.
3. Before installing electrical tray assembly, make sure
recessed cast housing (A) is clean, dry and free of
debris.
4. Unpack electrical tray assembly (B)
5. Remove splice compartment cover (if supplied).
NOTE: Appearance of electrical tray will vary depending
on the model ordered.
6. Mount electrical tray assembly into recessed cast
housing using the supplied 10-32 screws (located
in plastic bag). Use all screws provided.
7. Make electrical connections. Install in compliance
with the National Electrical Code, any applicable
local codes, and any specific instructions provided
on the luminaire labels. Supply wire must be rated
for 90°C minimum.
8. If supplied, replace splice compartment cover. Make
sure all supply wire connections are inside splice
compartment.
