www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United Stateswith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
3
INSTALLATION INSTRUCTIONS
MS_SR_090418
For technical assistance, call 1-800-4KENALL (1-800-453-6255).
CUSTOMER SERVICE
9. Discard any screws installed in corner posts of
recessed cast housing (screws were used to
secure debris shield.
10. Attach four (4) trim brackets (B) to recessed cast
housing (A) using the 8-32 screws provided in
plastic bag.
11. Install O-ring gasket (C) into recessed cast
housing. Make sure gasket ledge is free of debris.
Stretch gasket around four corner screw posts
and seat onto gasket ledge.
12. Remove lens or lens/eyelid assembly by loosening
the four (4) Torx
®
tamper-resistant screws. Screws
only need to be loosened enough to disengage
lens.
13. Prepare cast trim (D) for mounting to the recessed
cast housing. For wet locations, caulk backside of
cast trim perimeter. This is necessary to ensure wet-
location listing. Mount cast trim to trim brackets (B)
using the four (4) 10-32 screws provided.
IMPORTANT: When wall mounting; attach cast trim (D)
so that reflector-mount brackets (E) are at 12 o’clock
and 6 o’clock positions.
14. Mount reflector assembly. Install lamp and lens
or lens/eyelid assembly. Tighten the four (4) lens
retention screws.
For warranty information visit www.kenall.com/Resources/Certified-Performance-Warranties
WARRANTY
