Notch to front
and on top.
122”
Advice:
Prior to fastening walls and installing
rafters, take time to confirm your walls are level,
square and plumb.
Measure diagonal at top and bottom of walls
corner-to-corner. This should be approximately
122”. More importantly, if measurements are not
within 1/4”, your walls are not square. Adjusting
now will make it easier to install roof section
.
122”
19.
Attach
Door Header
to vertical door jambs with
2 - 2 1/2” Screws
per
side. Header is 3” wide at bottom and has a 1/2” thick x 2 1/2” wide strip of
wood stapled to the top creating a notch or dado effect. This notch needs to
be positioned on the top facing the front. The notch is necessary as the roof
panel may hang up on the header and must sit flush on the rafter tops when
attached.
Screw from door header into door jambs with 4 - 2 1/2” Screws
(2 per side). Pre-drill to prevent splitting!
Parts
Door Header
(2” x 3 1/2” x 35”)
x 1
Hardware
S1
- 2 1/2” Screws
x 4 total
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 14
