14.
Lay out all the wall
panels and become familiar
with their location.
On Standard Kits, there is
1 Window Wall Panel,
5 Solid Wall Panels and
2 Narrow Wall Panels.
Make sure to position panels
right side up so water is
directed away from and not
into shed. Look at window
wall panels to determine
proper wall position to
confirm.
15.
Starting at Rear Corner, position a Solid Wall Panel on
top of plywood floor. The Wall Panel bottom framing will sit
flush with plywood. Wall siding will overhang the floor.
Important:
Make sure all walls are aligned in their
upright position. If not ,water may leak into
your shed. Unsure if panel is facing up or
down? check siding on window wall panel
to match alignment.
16.
The side wall panels will sit flush at the end
of the plywood floor with the front and rear wall
panels sandwiched between them.
Note:
Siding will overhang the floor by approx.
1/2”
Outside 2x3 framing of wall panel
is flush with outside of plywood
when properly aligned.
Side Wall Panel
Front
Rear
of Shed
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 7