27
Instructions for the Installer
Positioning and Installation
•
The electrical installation of this appliance must be
carried out by an approved electrician or by trained
personnel
•
Local safety regulations must be adhered to.
•
In bathrooms, the AirCom Zentral is to be posi-
tioned in such a way that the electrical switch and
retractable rotary knobs cannot be touched by
someone in the shower or bath. In humid rooms,
the appliance may be installed in Protection area 3
(according to VDE 0100, Part 701).
•
Make sure that the exterior grille on the fresh air
and exhaust air ducts are regularly cleaned. Install-
ing the appliance under a window aids this consid-
erably.
•
If the AirCom Zentral is installed in multi-unit build-
ings for which separate billing per apartment is
executed, this can only be realised through heat
meters, it cannot be realised through tube evapora-
tors or similar devices. The reason is that due to
the different flow speeds of the incoming air over
the radiator an exact determination of consumption
cannot be ascertained through the evaporation
principle.
Procedures to be followed
Following safety standards are to be adhered to at
both planning and installation stages:
•
VDE 0100
(Construction of high-voltage installations up to
1000V)
Choosing the position
The ventilation appliance is designed to be mounted
on an external wall, as the fresh-air and exhaust-air
ducting must be run to the outside. Preferably, a posi-
tion under a window should be chosen, as the cold air
sinking from the window will then be directly heated.
The wall must be able to take the weight of the appli-
ance. Please, therefore refer to the weights given in
the "Technical Data" section. If there is any doubt as
to the strength of the wall, consult an expert.
Device-side preparation for installation
The ventilation appliance should only be removed
from its packaging near to its place of final assembly.
Note:
Do not lift the appliance out of the packaging
by means of its top or front panel! The top and
front panels are only loosely fitted!
•
Unpack the appliance.
•
Remove the front panel. To do this, push the front
panel approx. 1cm towards the top side of the ap-
pliance and pull it forward and away.
•
Pull the top panel upwards out of the spring shack-
les, then tilt it towards the rear in order to remove it
from the slider (Pos.3).
Fig.1
•
Remove the wall-mounting strip. To do this, re-
move the screws (Pos.1) and take off the bracket
to the rear.
•
Take the appliance off the wooden palette. To do
this, remove the screw (Pos. Z). The appliance will
tend to tip backwards when doing this, thus only
remove the appliance from the palette once the
wall-mounting strip has been attached to the wall
and the appliance can be immediately mounted
onto it.
Z
1 1
3
2
