20
•
Fixing the wall-mounting/tilt-safe bracket:
Drill two holes in the wall with a clearance C ac-
cording to fig.11a and fig.11b.
Use wall-plugs (Ø6x30) provided.
Note:
Use the heater rear panel as a template to
mark the hole positions. Place the heater
against the wall and mark the screw slots
through the heater panel. The drill holes
must correspond to the lower part of the
slots (fig.11b, Detail E).
fig.11a
fig.11b
fig.12
The heater is fixed from the front, through the rear
panel, using the fixing materials provided (2 screws
each 5x100mm, clearance spacers 12mm long and
clearance spacers 50mm long).
The clearance spacers are in the packaging and
can be slipped over the fixing screw. The length of
spacer chosen depends on the necessary clear-
ance to the wall.
fig.13
For skirting boards up to 70mm in height, the
heater can be placed flush to the wall (fig.14, Detail
A).
For skirting boards with a height of 70 to 120mm
the heater must fixed using a wall clearance
spacer (fig.14, Detail B), so that enough air can
circulate under and behind the heater.
Skirting boards of more than 120mm height must
be cut out in the area around the heater. The
heater is then fixed using the clearance spacer as
shown (fig.14, Detail B).
fig.14
14/712-3
14/713-3
14/714-3
C 514 734 954
