Olivetti d-Color MF220, Копирование операций

Страница: 232 / 315

Troubleshooting table 9
9-10 d-Color MF360/280/220 (Version 3)
9.2
[Replenish paper.] The indicated tray has run out of
paper. Add paper. (p. 8-4)
[Toner (Y) is low. Replace when
indicated.] The toner for the indicated color
is about to run out. Prepare a spare
Toner Car-
tridge
for replacement following
the guidance contained in your
maintenance agreement.
[Replace toner cartridge (Y).] The toner is about to run out. Replace the
Toner Cartridge
following the guidance contained
in your maintenance agreement.
[Toner is depleted. Replace the
toner cartridge following the
guidance (explanation). Press
the [Continue] button to contin-
ue the operations.] Toner is depleted. Replace the
Toner Cartridge
following the guidance contained
in your maintenance agreement.
[No more staples. Replace the
staple cartridge, or cancel sta-
pling.] The staples have run out. Replace the
Staple Cartridge
.
[Misfeed detected. Remove pa-
per according to the instruc-
tions.] Since a paper jam occurred, the
machine is unable to make cop-
ies. Clear the jammed paper.
[Empty the hole-punch scrap
box. To continue the job, cancel
punching.] (1) The hole-punch scrap box is
full.
(2)The
Punch Scrap Box
is not
installed.
Throw punch scraps away from
the
Punch Scrap Box .
Install the
Punch Scrap Box
.
[Reset the following number of
originals.] After clearing a paper jam, it is
necessary to reload certain pag-
es of the original that have al-
ready been fed through the
ADF .
Load the indicated original pages
into the
ADF
.
[An internal error occurred.
Open and then close the front
door to remedy a problem. If the
trouble code appears again,
contact your Service Rep.] The machine malfunctioned and
is unable to make copies. Take a remedy according to the
message displayed in the
screen. If the problem is not re-
solved or released, inform your
service representative of the
malfunction code displayed in
the screen.
[An internal error occurred. Turn
the main switch OFF and ON. If
the trouble code appears again,
contact your Service Rep.]
[Malfunction detected. Please
call your Service Representa-
tive.] The machine malfunctioned and
is unable to make copies. Inform your service representa-
tive of the code displayed in the
screen.
[Clean the original glass on the
left with the glass cleaner. Con-
tinuing using the machine in this
condition may cause lines to ap-
pear in the output.] The
Slit Scan Glass
is dirty. Use the
Slit Glass Cleaner
to
clean it.
[Now Downloading Program
Data from the Firmware server.] (1) CS Remote Care was acti-
vated by your service represent-
ative.
(2) Internet ISW is being down-
loaded.
Do not turn off the Sub Power
Switch
while this message is
displayed.
After turning off the
Sub Power
Switch
, turn off the
Main Power
Switch
, and then contact your
service representative.
[Authentication information en-
tered is invalid, due to failed ac-
cess attempts. Contact your
administrator.] The authentication information
has become invalid since the au-
thentication attempts have failed
the specified number of times. Contact the administrator of the
machine.
[Due to failed access attempts,
the current administrator pass-
word is invalid.] The administrator password has
become invalid since the authen-
tication attempts have failed the
specified number of times. Turn the machine off, then on
again.
Turn off the
Main Power Switch ,
and then wait at least 10 sec-
onds before turning it on again.
Message Cause Remedy