50
PLUMBING
WATER PUMP SWITCH LOCATIONS:
• A “PUMP” on/off switch is located on the SeeLevel II monitor located in the main cabin.
See the SeeLevel II Tank Monitor diagram later in this section.
• Another switch is in the bathroom above the towel bar in the vanity.
WHEN INITIALLY STARTING UP THE SELF-CONTAINED WATER SYSTEM:
1. Make sure the freshwater tank is filled with water.
2. Place the pump control switch in the ON position.
3. Allow time for the pump to fill the hot water tank and fully pressurize the system
(approximately 2 minutes).
4. The system is now ready for use.
⚠
WARNING
RUNNING THE WATER PUMP WITHOUT WATER FOR MORE
THAN 2 MINUTES MAY CAUSE PUMP FAILURE
NOTICE
THE SELF-CONTAINED WATER SYSTEM IS A DEMAND
SYSTEM. THIS MEANS THAT THE WATER PUMP WILL RUN
WHENEVER THERE IS A NEED FOR WATER.
TANK MONITORING
For operating instructions and troubleshooting, view the manufacturer’s manual.
The tank monitor consists of a display unit that mounts on an upper cabinet inside
the travel trailer, and sender panels that stick to the side of the holding tank. The tank
monitor will monitor the battery voltage, the freshwater tank, grey water tank, and black
tank.
NOTE:
The main water “PUMP” switch is located on the SeeLevel II Tank Monitor panel.
The green indicator light will illuminate when the water pump is turned on.
INLETS
CITY WATER INLET
The city water connection is located on the lower rear street side of the trailer. Water
provided from outside the Oliver is pressurized by the system from which it is delivered.
When you connect your Oliver to an outside source, the freshwater tank and the water
pump are kept separate from the remainder of the system by an in-line check valve.
Содержание LEGACY ELITE II 2023
