Dust Collection
The 4” dust collection port (A, Figure 4) is
located on top of the pressure roll carriage.
Typically flex hose is used to run from this
point to a central trunk line.
Figure 4
Do not operate the machine without dust
collection.
Electrical Connections
!
WARNING
Electrical connection and wiring must be
performed by a certified electrician. The
machine must be properly grounded.
Failure to comply may cause serious
injury!
This ripsaw is 3-Phase, 220V/440V
pre-wired
220V
. If you need to switch from 220V to
440V have a certified electrician make the
changes. Oliver Machinery recommends
using a dedicated circuit.
Figure 5a
Make sure the voltage of your power supply
matches the specifications on the motor plate
of the machine.
,
WARNING!
Prior to rotation check, raise the carriage
to ensure the 2
nd
row of kickback fingers
do not get caught in conveyor.
With 3-Phase power verify the blade is turning
in the proper direction. If rotation is incorrect,
swap two of the phases to reverse.
Note
: If running from a phase converter
ensure the ‘high leg’ of the converter does not
feed the control circuit of the rip saw.
!
WARNING
The 110 volt receptacle located on the
outside of the electrical box is for the laser
only. Failure to comply will result in
machine failure.
The main power connections are to be wired
to point A in the man control box as shown in
diagrams 5a and 5b.
Figure 5b
7