Oliver 4925 – 12” Ripsaw
Contents:
1. 12” Ripsaw
2. Key for electrical box
3. Fence
4. Rail
5. Instruction manual
6. Sawblade (installed)
7. Toolbox with the following
-arbor shaft wrench
-sawblade bolt wrench
-fence
handwheel
-oil
bottle
-allen key set
-10/12mm
wrench
Shown with Optional Laser and Bracket
-17/19mm
wrench
-phillips
screwdriver
-extra rubber chain inserts
-grease
gun
Tool Box Contents
-levelling
bolts
8. Laser and bracket (optional)
Uncrating the Machine
Uncrate the machine and inspect the unit for
signs of shipping damage. If damage is found,
contact your dealer immediately. Unbolt the
machine from the pallet Retain all packaging
materials in case it becomes necessary to ship
the machine to another site.
Machine Preparation and Setup
!
WARNING
The equipment used to lift this machine
must have a rated capacity at, or above the
weight of the ripsaw. Failure to comply
may cause serious injury!
The ripsaw must be positioned on a smooth,
level surface. The area must be well lit and
have plenty of room to maneuver with large
pieces of wood.
Level the saw front to back and side to side
using a level placed on the table. Use shims
under the corners, if necessary, but make sure
the saw is stable before being placed into
service.
Clean all rust protected surfaces with a
commercial solvent. Do not use acetone,
gasoline, lacquer thinner or any type of
flammable solvent, or a cleaner that may
damage paint. Cover cleaned surfaces with
WD-40 or a 20W machine oil.
6