Oliver 1808-D, Операции пользователя

Страница: 38 / 59

1808-D
1808S20060 10-2
SYMPTOM
CORRECTIVE ACTION
Poor seal quality (continued) Make certain that the heat seal roll down
stroke is adjusted correctly as explained
in the “MACHINE ADJUSTMENTS” section
of this manual.
Heat seal roll does not heat Make certain the machine is plugged into an
adequately rated electrical outlet.
Verify that there is power at the electrical outlet.
Check to see that the heated roll switch is in the “I”
on position.
Check the E-stop button – must be in released
position.
Check that Infeed gate is in place.
Check that Discharge cover is closed.
Check to see if heat seal roll is up to temperature.
Compare set temp and actual on digital
temperature control on side of electrical enclosure.
Check the fuses in the electrical enclosure to see if
any fuse is open (no continuity), if it is open,
replace it. (To be performed only by a Qualified
Service Technician)
Check the circuit breaker in the electrical enclosure
to see if it has tripped. If tripped, investigate cause
and reset. (To be performed only by a Qualified
Service Technician)
Continued