Oliver 10047VS, Руководство пользователя, Страница: 42 / 58

42 |
Page Oliver Machinery 10047VS Shaper
Difficult to turn spindle
height adjustment
handwheel
Handwheel is locked. Loosen handwheel lock knob.
Sawdust and dirt in
raising mechanisms.
Brush or blow out loose dust and dirt.
Lubricate spindle elevator lead screw as
needed.
Spindle gib too tight. Adjust spindle gib tightness.
Machine vibrates
excessively
Damaged cutter. Replace cutter.
Machine stands on
uneven floors.
Reposition machine on flat, level surface.
Use attached rubber feet to level machine.
V-belt not tensioned
correctly.
Adjust belt tension.
Bad v-belt. Replace v-belt.
Spindle gib wear. Adjust spindle gib pressure.
Damaged pulley. Replace pulley.
Improper motor
mounting.
Check and adjust motor mounting.
Motor/spindle bearing
issue.
Contact customer service for further
assistance.
Operation / Cut Quality Issues
Problem Possible Cause Solution
Work pulled from hand
Inadequate stock
support.
Hold work firmly against the table / fence.
Adjust the hold down pressure.
Use special jigs to support short stock.
For shaping short edges of a workpiece, use
miter gauge with clamp or hold down.
Feeding work in wrong
direction.
Feed work against cutter rotation direction.
Incorrect cutter rotation
direction.
Check and correct cutter rotation direction.
Removing too much
materials in one pass.
Make lighter pass or reduce feed speed if
possible.
Outfeed fence catches
stock
Outfeed fence not
adjusted correctly.
Reduce infeed/outfeed fence offset.
Warped stock. Ensure a flat surface is used to press against
the fence.
Edge splits off on cross
grain cut
Some wood types tend
to split with cross cuts.
Use sharp cutters and reduce depth of cut.
Make cross-grain cuts first then finish with
grain.
Use scrap block to support at the end of a cut.