Oliver 10047VS, Руководство пользователя, Страница: 12 / 58

12 | Page Oliver Machinery 10047VS Shaper
Safety Guidelines Specific to Shaper
Before Work Begin:
1. INSPECT CUTTER: Make sure cutters are sharp, clean, balanced and free from damages. Forcing dull
cutters to work invites accidents and impacts finish quality.
2. CUTTER POSITIONING: Whenever possible, position the cutter below the workpiece and make blind
cuts with hold-downs. Doing so reduce operator’s exposure to the cutter.
3. SECURE SPINDLE AND CUTTER: Make sure the spindle and the draw bar are tightened on the arbor.
4. KEYED COLLAR: Never operate the shaper without the keyed collar located
immediately under the spindle washer. Key collar prevents the cutter from coming
loose when the spindle rotates. Do not substitute any other type of washer/spacer in
place of the keyed collar.
5. CUTTER CLEARANCE: Adjust fence plates and guard, and use correctly sized table inserts to create
practically minimal cutter clearance. Never start shaper with workpiece touching the cutter.
6. CHECK SPINDLE SPEED AND SPINDLE-FEED DIRECTION: Always start this shaper at the lowest speed,
and never set rotation speed above the rated RPM of the cutter. Always feed stock against cutter
rotation direction to maintain better control of stock.
7.
CHECK STOCK LENGTH:
Never shape stock less than 12 inches in length without special fixtures. When
practical, shape longer stock and cut to size.
8. SHAPE ONLY QUALITY WOOD: This machine is designed for wood products only. Do not shape any
material other than wood. Do not attempt to shape workpiece with loose knots or with any other
foreign material. Do not attempt to shape twisted, warped, bowed stock. Use a jointer to flatten stock
prior to shaping.
9. COLLARS: When shaping with collars, the collar must have sufficient bearing surface. The work must
also be fairly heavy in proportion to the cut being made. Do not use short, lightweight stock when
shaping against collars.