17
System Setup
-
Set Downmix:
select different Audio output mode:
“LT/RT”: means with left and right CH audio effect.
“Stereo”: indicates the normal stereo sound.
”V SURR”: shows the audio output is of surround signal.
“5.1ch” : means 5.1CH output. Change 5.1 to OFF
(
Note
: If connected to an amplifier with 2 CH signal input, “LT/RT” mode could be chosen, this will transfer the
2 CH signal to amplifier for processing.)
- Set Front Speaker :
To choose “Large/Small” for the front speaker output.
- Set Centre Speaker :
under the “Downmix Off” mode, can select “Large/Small or off” output.
- Set Rear Speaker:
under the “Downmix Off” mode, can select “Large/Small or off” output.
(Note:
“Large” means complete frequency audio speaker output; “Small” means high frequency speaker.
Use actual speakers configuration to adjust supper low frequency. If small speaker is connected, don’t choose
“Large” setting, otherwise a high volume could damage the speaker; “Centre speaker” & “Rear speaker ”
setting only can be done under the condition of “Downmix” being set with 5.1CH” or “OFF”).
- Set Subwoofer:
To choose “On/Off” for the subwoofer, “On “ means the woofer is used.
-
Set Test Tone :
With 5.1 operating, choose “On”, this will check 5 CHs in turn.
(Note: this setup must be done under condition that no disc in the unit and under the condition of “Downmix”
being with 5.1CH” or” OFF “, this setup is used to check whether all CH linkage with sound box is correct or
wrong.
- Set Dialog :
When “Audio output mode” is set as “LT/RT or stereo ” output, under the “Speaker Setup Page ”
mode, you can set the “Dialog ” item and adjust volumes. when playing 5.1CH disc, you can adjust speakers
volumes via “dialog”.
- Select Post DRC:
Dynamic compress output can lower volumes, the sound effect will work under speakers’
max output. The item is divided into “on
ǃ
off
ǃ
auto”.
2. SPDIF Setup Page
Move
ǃ
direction buttons in the audio setting menu page to choose “ SPDIF Setup Page” and press
Ǐ
PLAY
ǐ
button to enter the digital audio setting page, and press
ǃ
direction buttons to choose SPDIF Output and
LPCM output.