Olimpia splendid Ci2 Wall Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 56 / 132

ENGLISH
EN - 24
7 - INCONVENIENCES AND POSSIBLE REMEDIES
Consult the following points before requesting assistance or repairs.
Do not try to repair the appliance by yourself.
If the problem has not been solved, please contact your local retailer or the closest assistance service.
Supply detailed information about the malfunction and the equipment version.
CAUSE
• Electric current failure.
• Switch is off.
• Switch fuse probably blown.
• Remote control batteries discharged or
remote control broken
• Temperature not set correctly
• Accumulation of dirt in the appliance heat
exchanger coil
• Air filter dirty
• Obstruction of the appliance inlet
• Doors and windows open
• Exposure to direct sunlight
• Too many heat sources
• Outdoor temperature too high
• Outdoor temperature lower than 7°C
• Doors and windows partially open
• Control that the MODE indicated on the
display is AUTO (automatic)
• Protection against hot air in cooling mode
• Protection against cold air in heating
mode
• Verify that the batteries of the remote
control are not discharged
• Control that the MODE indicated on the
display is FAN (ventilation)
• Check that the appliance stops when the
display shows the TIMER OFF indication
(switch-off timer)
• Check that the appliance starts when the
display shows the TIMER ON indication
(switch-on timer)
• Check that the remote control signal
transmitter is aimed correctly towards
the appliance infra-red receiver when
the
ON/OFF
key (P5) is pressed.
WHAT MUST BE DONE?
• Wait for the electric current to reset.
• Switch the unit on.
• Replace the fuse.
• Replace the batteries or examine the
remote control.
• Set the correct temperature.
• Clean the heat exchange coil.
• Clean the filter.
• Eliminate the impurities to free the air
flow.
• Close doors and windows.
• Protect from solar rays via curtains.
• Reduce the heat sources.
• The conditioner cooling capacity lowers
(normal).
• Use a heating device.
• Close doors and windows.
• If automatic mode is selected, the
conditioner automatically adjusts the
fan speed.
• Lower the inlet temperature in cooling
mode; increase the inlet temperature
in heating mode.
• The electric current is cut off.
• In ventilation mode, the temperature
cannot be set.
• The conditioner will switch off at the
time set.
• The conditioner will switch on
automatically at the time set and the
relative indicator will switch off.
• Aim the remote control signal transmitter
directly towards the appliance infra-red
receiver and then press the
ON/OFF
key twice (P5).
MALFUNCTIONING
• The appliance does not start
• The air circulates regularly, but cooling
is insufficient
• Cooling not very effective
• Heating not very effective
• Impossible to modify the fan speed
• The remote control signal is not
transmitted, even if the ON/OFF key is
pressed
• The TEMP indicator does not switch on
• The indication on the display disappears
after a certain period of time
• The TIMER ON indicator switches off
after a certain period of time
• The appliance does not emit any sound,
not even when pressing the ON/OFF key
(P5)