ENGLISH
EN - 7
1.1 - PREPARATION BEFORE INSTALLATION
Check that the following are present in the package:
No
Name
Qty
Remarks
1
Remote control
1
-------------
2
Round cross-tip screwdriver
3
M4x20
(For wall mounting)
3
Round cross-tip screwdriver
2
M4x25
For mounting on the box
of the electric switches
4
Installation and use manual
1
-------------
5
Expansion plugs
3
For wall mounting
6
Plastic support
2
For mounting on the box
of the electric switches
7
Switching cables
for the signal receiving board
1
For reception of the signal
shielded cables with 4 wires
8
Switching cables for signal via cable
1
(If necessary)
For connection of the main control panel and
the shielded cable with 4 wires
1.2 - PREPARE THE FOLLOWING (NOT SUPPLIED)
No
Name
Quantity
(inserted
into the wall)
Features
(for reference
only)
Remarks
1
Switching cables
for the signal receiving board
1
RVVP-0.5mm
2
x4
longer by
15 metres
2
Electric box
1
----------
----------
3
Wiring tube
(insulating sleeve
and clamping screw)
----------
----------
NOTE FOR INSTALLATION OF THE REMOTE CONTROL:
1. This installation manual contains information regarding installation and use of the remote control.
Refer to the appliance installation manual for connection between the latter and the remote control.
2. The wiring circuit between the appliance and remote control is low voltage.
Do not connect them to a standard 220V/380V circuit or introduce the wiring into the duct with live
cables.
3. The shielded cable must be connected to earth. If this is not the case, it may not operate correctly.
4. Do not attempt to extend the shielded cable. If necessary, use an extension cable with relevant joint
connector.
5. When the connection has been made, do not use a tester to control the level of isolation on the signal
cable.
