Olicom 710001414, Руководство по эксплуатации

Страница: 72 / 88

65
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Driver Messages
Failure: Invalid IOBASE specified in PROTOCOL.INI.
The IOBASE parameter is present in the OCE3X section of the PROTOCOL.INI file, but the parameter
specified is not valid. Remove the IOBASE entry in PROTOCOL.INI or change the IOBASE parameter to a
legal value. If the IOBASE entry is present in PROTOCOL.I NI, the value must match the I/O address
setting for an installed adapter.
Failure: Invalid burned in address or checksum.
The EEPROM contained an invalid burned-in address or the checksum stored was not correct. Run adapter
diagnostics.
Failure: Invalid Interrupt read from adapter.
The Interrupt read from the adapter is invalid. Change the interrupt selection on the adapter abd retry the
operation.
Failure: No adapters found.
The driver could not find an Ethernet Adapter at any valid I/O address. If the IOBASE keyword is not
present in the OCE3X section of the PROTOCOL.INI file, the driver will search for an adapter at all valid
I/O addresses. If no adapters are found at any of the valid I/O addresses, this message is displayed.
Otherwise, the driver will inform you of the I/O address where the adapter was found in the MAC Driver
installed information string.
Failure: EEPROM checksum error, Run diagnostics.
The EEPROM checksum stored was not correct. Run adapter diagnostics.