Olicom 710001414, Руководство по эксплуатации

Страница: 26 / 88

19
Ethernet MCA 10/100 Adapter v. 1.0, P/N: 710001414 Software Installation
Duplex (Auto, Half duplex, Full duplex)
This parameter can be used to force the Ethernet MCA 10/100 Adapter into a
specified duplex mode, that is full or half duplex. If “Auto” is selected,
the Ethernet MCA 10/100 Adapter will auto-negotiate the duplex mode and
use the best possible value. In some hubs and switches the auto-negotiation of
duplex operation is unresolved. In such cases half duplex operation will be
used. If full duplex operation is required, use “Full Duplex” to force this mode.
Network address
Use the network address field if you do not want to use the adapter's burned-in
Ethernet address.
The address entered may be preceded by an address format identifier (I or T), I
is for IEEE standard address format also known as canonical or LSB format. T
is for IBM Token-Ring Network format, also known as non-canonical format
or MSB format. The IEEE standard notation will be used if this identifier is left
out.
The value must be a locally administered address. If the IEEE standard
notation is used, the address must be in the following format:
IX*XXXXXXXXXX or just X*XXXXXXXXXX, where X is any
hexadecimal digit and * is either 2, 6, A, or E.
Example: 060012345678
If Token-Ring Network format is used, the address must be in the following
format:
T*XXXXXXXXXXX,
where X is any hexadecimal digit and * is either 4, 5, 6, or 7.
Example: T400012345678
NDIS 3.0 Error Messages
NDIS 3.0 error messages and suggested actions are described in appendix B.