Oleo-Mac MB 90, Инструкция для оператора

Страница: 8 / 39

24
GB
5. STARTING
FUELING
WARNING: Gasoline is an extremely
flammable fuel. Use extreme caution when
handling gasoline or fuel mix. Do not smoke
unit.
·
To reduce the risk of fire and burn injury,
handle fuel with care. It is highly flammable.
· Mix and store fuel in a container approved for
gasoline.
· Mix fuel outdoors where there are no sparks or
flames.
· Select bare ground, stop engine, and allow to
cool before refueling.
· Loosen fuel cap slowly to release pressure and
to keep fuel from escaping around the cap.
· Tighten fuel cap securely after refueling. Unit
vibration can cause an improperly tightened
fuel cap to loosen or come off and spill
quantities of fuel.
· Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting engine.
· Never attempt to burn off spilled fuel under
any circumstances.
· Do not smoke while handling fuel or while
operating the unit.
· Store fuel in a cool, dry, well ventilated place.
· Never place the machine in a combustible area
such as dry leaves, straw, paper, etc.
· Store the unit and fuel in an area where fuel
vapors cannot reach sparks or open flames
from water heaters, electric motors or switches,
furnaces, etc.
· Never take the cap off the tank when the
engine is running.
· Never use fuel for cleaning operations.
· Take care not to get fuel on your clothing
9. In case you want to exclude the passage
of liquids through the handle, connect the
liquid hoses as shown in square B, using the
plastic transparent connector present in the
spanners bag.
10. To get a wide exit, insert the wide spray jet
(15, Fig.1) on the spreader (14).
Adjusting the control handle
Correct positioning of the control handle is
e x t r e m e l y i m p o r t a n t i n o r d e r t o w o r k
comfortably with the mist blower. To adjust the
control handle position:
1. Raise the locking lever (1, Fig.5).
2. Find the most comfortable working position
by sliding the control handle and adjusting
its angle.
3.
control handle by lowering the locking lever.
Adjusting the harness and quick release
WARNING - The harness must be adjusted
with the engine stopped.
Before using the mist blower it is extremely
important to ensure the weight of the machine is
correctly balanced on your shoulders. This is done
by adjusting the length of the shoulder straps
until the machine is perfectly in contact with your
back and shoulders.
Note that correct balancing of the machine is
especially important when working on gradients.
To tighten the shoulder straps pull as shown in
To loosen the shoulder straps lift the buckle with
In the presence of danger, release the machine
from your shoulders by proceeding as follows:
1. Use one hand to press the quick release tabs
on the right-hand shoulder strap (shown in
2. Accompany the machine by bending your
upper body slightly to the left: the mist blower