Oleo-Mac MB 90, Инструкция для оператора

Страница: 10 / 39

26
GB
· Check that the switch (2, Fig.13A) is in position
“1” (on).
· Place your left hand on the engine cowling
and your left foot on the frame to keep the
machine steady.
· Use your right hand to pull the handle (4, Fig.1)
until you encounter slight resistance. Without
releasing the rope, pull with a short sharp
· When you hear the engine fire for the first
time raise the choke lever (B, Fig.12) toward
its vertical position until it clicks into place
(Fig.11).
· Pull the handle once again to start the engine.
Keep the engine at idle speed for at least one
minute before accelerating to full revs.
Starting with a warm engine
· Press the primer bulb (A, Fig.12) fully down,
slowly, 10 times.
· Raise the choke lever (B, Fig.12) until you hear
a click.
· Check that the switch (2, Fig.13A) is in position
“1” (on).
· Place your left hand on the engine cowling
and your left foot on the frame to keep the
machine steady.
· Use your right hand to pull the handle (4, Fig.1)
until you encounter slight resistance. Without
releasing the rope, pull with a short sharp
· Keep the engine at idling speed for at least one
minute before accelerating to full revs.
· Remove the spark plug (3, Fig.1) using the
supplied wrench, then clean it and dry it.
· Check that the choke lever B is in its horizontal
position as shown in Fig.11.
· Pull the starter handle (4, Fig.1) at least 20
times.
·
to the max revs position (4, Fig.13).
· Start the engine.
If the engine fails to start, proceed as follows:
· Remove the spark plug using the supplied
inspect the gasket.
5. Immediately replace fuel cap and hand
tighten. Wipe up any fuel spillage.
WARNING: Check for fuel leaks, if any are
found, correct before use. Contact a Servicing
Dealer if necessary.
Controls handle (Fig.13A)
· To accelerate press throttle trigger (1) together
with safety lever (3).
· To start the engine switch (2) must be set to “1”.
·
speed, press safety lever (3) and move lever
(4) towards the “+” mark until obtaining the
required engine rpm. To disable the fixed
speed setting, return the lever to the “-”
position.
· To stop the engine, set switch (2) to “0”.
Observing the Fig,13B:
The switch (5) activate or block the automatic
opening of the liquid tap included in the handle.
· When the switch is in low position, the opening
of the tap is automatic while accelerating. With
the throttle at the idle, the tap remains closed.
· When the switch is in high position, the tap is
always open whatever it is the position of the
throttle. To slide the switch (5) upward, it is
necessary to press simultaneously the throttle
lever (1, Fig.13A).
Starting
Before starting the engine:
·
· Check that the switch (2, Fig.13A) is not in
· Make sure that there is no one near the
machine and/or in front of the mist blower
tube.
Starting a cold engine (engine stopped for
more than 30 minutes)
· Press the primer bulb (A, Fig.12) fully down,
slowly, 10 times.
· Lower the choke lever (B, Fig.12) until you hear
a click.