User Manual LR-1BS35
OMEN-1BS35-202202
16
Appendix F Cleaning of sensor
OLE-LiDAR, especially the ring-shaped protective cover, should be kept clean in order to
accurately sense the surrounding environment.
F.1
Notice
Please read Appendix E thoroughly and carefully before cleaning OLE-LiDAR, otherwise
improper operation may damage the equipment.
F.2
Materials required
1. Clean fiber cloth
2. Neutral soap spray
3. Clean water spray
4. Isopropanol solvent
5. Clean gloves
F.3 Cleaning method
If there are only some dust on the surface of the LiDAR, directly use a clean fiber cloth
with a small amount of isopropyl alcohol solution to gently wipe the surface of the LiDAR, and
then wipe it with a dry and clean fiber cloth.
If there are mud or other blocky foreign matter on the surface of LiDAR, first spray clean
water on the surface of the dirty part on the LiDAR to remove the mud and other foreign matter
(Note: please do not wipe off the mud directly with a fiber cloth, as this may scratch the surface,
especially the surface of the protective cover). Then spray with soapy water on the dirty parts,
since the lubricating effect of soapy water could accelerate the separation of foreign materials.
Gently wipe the surface of the LiDAR with a fiber cloth, be careful not to scratch the surface.
Finally, clean the soap residue on the LiDAR surface with clean water (if there are still residues
stains on the surface, use an isopropyl alcohol solution to clean it again), and wipe it with a dry
microfiber cloth.
