OLEI LR-1BS3, Руководство пользователя

Страница: 12 / 19

User Manual LR-1BS35
OMEN-1BS35-202202
10
7.2.
Configuration of OlamViewer
The OlamViewer interface is shown as following. Please refer to OlamViewer software
manual for detail.
Figure 13 Sample of The OlamViewer interface
The Web page setting interface and The OlamViewer interface may change due to
continuous update of products and is subject to actual content.
8. Troubleshooting
Table 5 Troubleshooting
Problem Method
LiDAR fails to
scan

Verify whether the power supply is properly connected

Verify whether the power voltage meets 12~32VDC

Please contact OLEI if the above conditions are normal.
LiDAR scan
produces no data

Verify whether the network connection is normal

Verify whether the IP settings on the data receiver are correct.

Try to use third-party data scraping software to verify whether data could
be obtained normally

Verify whether only one LiDAR software is enabled.

Verify whether firewall of the data receiver is disabled or if there are
other security software or processes blocking data transmission.

Please contact OLEI if the above conditions are normal.
LiDAR can not
respond when
obstacle is detected

Check if the software configuration is correct and if the
configuration file is successfully downloaded
.

Verify whether the wiring at the I/O port is correct.

When the I/O port is not
not connected
, Bank 0 is the effective field
group by default.

The I/O port is only connected to VCC and GND. When other PIN are
not connected, Bank 15 is considered to be the valid field group by
default.

Please contact OLEI if the above conditions are all normal.