User Manual LR-1BS35
OMEN-1BS35-202202
8
7.
Parameter configuration
7.1.
Parameter configuration of web page
Web page parameter configuration method of LR-1BS3/5 is as follows:
Open the browser (please use
Chrome,Firefox, Edge
or other standard browsers), and
enter the LiDAR IP address;
"
Model
" and "
Version
" at the top of the UI indicate the product model and firmware
version;
"
Temperature
", "
Voltage
" and "
SafeAre
a" on the right side of the UI are the LiDAR
parameters displayed in real time, indicating the temperature, voltage and current active
Bank. When the font color of parameter turns red, please check whether the LiDAR is
malfunctioning;
Automatically read the current settings of LiDAR by refreshing the page;
Select the desired speed through "
Motor RPM
": 600/900/1200/1500
(The corresponding scanning frequency is 10/15/20/25HZ ), and click "
SetConfigs
" to
confirm;
Set the LED indicator
ON
and
OFF
through "
Led Marquee
", and click "
Set Configs
" to
confirm;
Set the
ON
and
OFF
of the LiDAR safety function through "
Safe Area
", and click "
Set
Configs
" to confirm;
Select input mode of "
safe bank
" trough "
Safe bank input
"
(
GPIO mode is not available for
1BS3/5)
;
Set the mode of the LED indicator through "
Led Mode
";
Select current Bank through "
Safe bank config
" when "
Safe bank input
" is “
Software
”;
Set receiving computer IP and port through "
Host IP & Port
".Up to 3 groups can be set.
Click to add a group, click
to delete a group.
Enable/disable the
DHCP
function: the LiDAR dynamically obtains an IP address from the
DHCP
server (ON), and the LiDAR needs to set up a static IP address (OFF);
Modification of LiDAR IP: Enter the new IP into the LiDAR IP column (must be in the
same network segment as the local IP), click the "
Set Network
" to confirm, and the
modification is complete after the LiDAR is powered on again
