![background image](http://html1.mh-extra.com/html/oldham/denchi-power-gl9/denchi-power-gl9_instruction-manual_3717531006.webp)
6
3. Unscrew secondary bulb from side socket
assembly of headpiece housing.
4. Thread the new secondary bulb into the socket
assembly (do not over-tighten).
5. Place the hole in the reflector over the
secondary bulb.
6. Reassemble the glass (lens) and bezel to the
headpiece assembly.
Replacing the reflector
1. Remove the bezel ring and lens.
2. Remove the reflector from main bulb bush
connection.
3. Remove gasket around reflector.
4. Place the gasket around the new reflector.
Ensure the gasket is in place all the way
around reflector.
5. Thread the reflector onto the bush connection.
6. Reassemble the lens and bezel ring (see
Reassembling of bezel ring).
Replacing the Cable
1. Remove the cable from the battery
terminals.
2. Cut the cable tie which secures the cable
under the battery cover, and gently pull the
cable out of the battery cover gland.
3. Unscrew the battery collar / cable outlet
gland from the headpiece.
4. Remove the bezel ring (see “removing the
bezel ring”) and glass from the headpiece.
5. Use the spring screwdriver to remove the
screws holding the cable terminals inside
the headpiece, and gently pull the cable
out of the side aperture.
Note: Take care to note the correct polarity of
the cable so that reassembly is correctly
achieved, and the battery is not “reverse
charged”.
6. To replace the cable reverse the above
procedure.
Note:- Always remember to refit the cable outlet
gland over the cable before commencing
reassembly.
Reassembling the bezel ring
When the lens is in position over the reflector, the
bezel ring is locked in position by a hex headed
lock screw that fits into a countersunk hole and
then enters one of the slots in the bezel ring.
The countersunk hole enclosing the lock pin can be
filled with wax if desired.
Содержание Denchi Power GL9
Страница 9: ...9...