background image

Easy Fountain Instructions
45050L - Woodland Falls

www.kelkay.com

STAGE 1

Position the water feature onto a secure and level surface.

STAGE 2

STAGE 3

STAGE 4

STAGE 5

As shown in the diagram above locate the access cavity / water reservoir at the back of the water feature. 
Reach inside the feature and carefully bring out the internal water pipe and the LED cables.

The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.

Please read the assembly and pump operating instructions carefully and observe the safety instructions.

Carefully fill the feature with sufficient water taking care to ensure the pump is fully submerged.

Position the pump and excess wires inside the access cavity / water reservoir ensuring that the long pump 
and LED wire extend out through the opening. Replace the back trapdoor to cover the opening.

Attach the internal water pipe to the pump outlet and connect the internal LED wires to the adaptor plug 
provided.

ELECTRICAL SAFETY:

 If outdoors the outlet must be waterproof. We 

recommend the use of a residual current device (GFI) Ground Fault 
Interrupter (available from all good D.I.Y. stores) when connecting the 
fountain to the electric supply. 

PUMP FLOW:

 The pump flow can 

be adjusted with the regulator, this 
is found on the inlet of the pump. 
We recommend starting with the 
flow regulator fully open and then 
adjusting down if required.

STAGE 6

Connect the pump and LED adaptor to a mains power outlet.

Reviews: