INSTALLATION INSTRUCTIONS
Model # 72321/72322
READ AND SAVE THESE INSTRUCTIONS
W
A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the circuit breaker (avertissement!
couper le courant au niveau des fusibles ou du
disjoncteur) and remove the old the fixture including the
mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts in a clear area. Take care not to misplace any
small parts necessary for installation.
3. Thread the two studs (B) into the pre-drilled holes in the
circular strap (C) (Part#A-020)
spaced the same
distance apart as the holes in the back plate (H),
and
secure with hex nuts (E). Note: The length of studs (B)
into circular strap (C) may be adjusted if necessary.
4. Attach circular strap (C) (Part#A-020) using mounting
screws (F) (Part#8/32
”*1”L) to the outlet box (A), (Fig 1).
CONNECTION THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2.Making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the circular strap using
the green screw (D) (Part#8/32
”*1/3”L) provided.
FINISHING THE INSTALLATION (Fig.1)
6. Align back plate (H) onto studs (B) and secure with cap
nuts (G).
(Fig 1)
7. To prevent moisture from entering the outlet box (A)
and causing a short, use clear silicone Sealant to
outline the outside of fixture back plate (H) where it
meets the wall leaving a space at bottom to allow
moisture a means to escape (Fig 3).
8. At this point, use the suction cup provided to install
1*35W /GU10 bulb (two bulbs included) in accordance
with the fixture specification. -----
DO NOT EXCEED
THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER
LA
PUISSANCE
NOMINALE
MAXIMALE!)
9. Align the crystal shade (J) to the top cover. While
supporting the crystal shade (J), secure it in place with
metal holder (K) and screw (I)
Remark: If the crystal is not seating securely into the metal
holder (K), Use the silicon ring provided to help level the
crystal and secure it within the metal holder (K).
Your installation is now complete. Return power to the
outlet box and test the fixture.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
Fig. 1
Set:
Circular Strap
Ground screw(1)
Mounting screws(2)
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
Fig 3
Caulking
Backplate
