![background image](http://html1.mh-extra.com/html/oldham/denchi-power-gl9/denchi-power-gl9_instruction-manual_3717531004.webp)
4
Charging before first use:
1. Allow the battery to remain on charge for 24
hours.
2. After a working shift, the battery should be
placed on the charger, following the
instructions included with the charger, and left
to charge. The charger automatically switches
off when the battery is completely charged
3. If cap lamp needs cleaning, use a mild
detergent and wipe. Do not submerge in water.
Battery Storage
All stored batteries should be given a 24-hour boost
charge 3 months after receipt and thereafter at 6-
monthly intervals until use, where they should
again be fully charged before being placed into
regular service.
Recommended storage temperature: 0
o
C to 27
o
C.
Replacing battery
1. Remove one M4 button head socket screw
from the end clamp holding the cover as
shown.
2. Un-clip the clamp and slide off the cover to
cable end.
3. Remove the positive cable lead (red)
4. Remove the fuse
5. Remove the negative lead (black)
Replacing battery cover
1. Replace the fuse; fit the nuts to hold the fuse in
place
2. Connect the red cable to the positive battery
terminal.
3. Connect the black cable to the negative battery
terminal to ensure correct polarity.
4. Tighten the cable leads down with terminal
nuts to 0.5Nm.
5. Replace the battery cover.
Note:
Ensure that the cable leads lie properly on the
battery top without being trapped or pinched.
USING THE GL9/GL16 CAP LAMP SYSTEM
The G headpiece is made up of the lamp-housing
which contains the following parts:
-
Bezel (ring)
-
Lens (glass)
-
Gasket
-
Reflector
-
Main bulb
-
Secondary bulb
The on-off switch knob is located on the side of the
headpiece. To operate the lamp:
1. Turn the switch knob clockwise to main bulb or
anti-clockwise to secondary bulb.
2. After use turn the switch knob until both bulbs
are off.
Содержание Denchi Power GL9
Страница 9: ...9...