Installing the Filter
A.There are differences between the inside and the
outside of the dust filter 1 (antibacterial cotton
filter and HEPA filter). Attention: The side with a
handle should be placed outwards
B
.
There are differences between the inside and the
outside of the absorption filter 2 (Cellular -Activated
Carbon Filter and cold catalyst filter).
Attention: The side with a handle should be placed
outwards
C
.
There are differences between the inside and the
outside of the front filter (pre-filter). Attention: The
side with a handle should be placed outwards
D.Install the front cover
05
04
1. Removing the filter from the
plastic bag:
2. Installing the filter and front cover.
A. Remove the front cover.
B. Remove the filter.
C. Take the filter out of the
packaging.
※
Make sure to remove plastic bag off the
filter before use.
※
The machine will not run if the front panel is
uncovered.
Prepare for humidification
1. Pull the water tank out from the side of the
purifier.
2. Remove the package of the humidifying
filter.
3. Put the humidifying filter into the water tank.
4. Open the rubber lid of the inlet.
5. Add about 1L cold water through the inlet,
filling around 80% of the water tank.
6. After adding water, close the lid.
7. Push the tank back into the purifier.
8. This machine has evaporative
humidifying function.
If water is added into the water tank, the machine
will generate steam automatically. The
humidification effect is related to the wind speed,
and it works better when the machine is operating
at a higher gear. If the water level becomes low, the
indicator light will flash while the machine
continues working normally.