Okofen PELLEMATIC SmartXS, Руководство по установке

Страница: 15 / 100

Flue gas system
15
before water enters the boiler room. All components that come into contact with water must be replaced
before the pellet boiler is put into operation again.
6.3 Flue gas system
The flue gas system consists of the chimney and flue gas tube. The connection between pellet boiler and
chimney is the flue gas tube. The chimney directs the flue gases produced from the pellet boiler into the
atmosphere.
1. Design of the chimney
The dimensions and form of the chimney are critical to proper system function.
The chimney must ensure a sufficient negative draft in all operating states of the boiler for reliable dis-
charge of the flue gases.
Low flue gas temperatures result in the formation of condensation.
Moisture-resistant chimneys of stainless steel or ceramics must therefore be used. Chimneys made from
plastic are fundamentally not permitted for pellet heating systems.
An existing chimney that is not moisture resistant must be modified accordingly. The flue gas tube must
be of stainless steel.
The joints must be oriented correctly and sealed to prevent the escape of condensation.
Installation without barometric control / draft controller is advised.
Chimney diameter 5 inch. And in accordance with chim-
ney calculation method EN 13384–1
Chimney design Moisture tollerant
Note:
Use a draft gauge to verify the indicated draft value. Drill a small hole in the connection pipe at about
2in/ 50mm from the boiler flue outlet and use this hole as your measuring point.
2. Connection pipe
T Th he e ffllu ue e g ga ass lliin ne e h ha ass tto o iin nc cllu ud de e a a c clle ea an niin ng g p po orrtt a an nd d a a
ffllu ue e g ga ass tte esstt p po orrtt..
Note:
Keep accessibility and cleaning in mind when laying out and planning the flue pipe location and
orientation.
Flue pipe connection at boiler (ID) 5.19 inches - (compatible with 5 inch)
Maximum length of flue pipe 13 feet or local regulations
Temperature rating T-400
Tightness class N1 or P1 as per chimney calculation yet
generally condensate-proof - Use of
seals recommended
Execution
stainless steel version, condensate-
proof –(use of seals recommended),
moisture- and corrosion-resistant
3. Flue gas temperature
Boiler-type PESmart
Flue Gas Temperature FGT Power
rating
113–176° F
Installation Manual PELLEMATIC® SmartXS