Page: 38
Service Guide OL400
Chapter 3 Maintenance & Disassembly
3.2.02 LED Head
1. Perform this procedure:
3.2.01{
}
2. Push the two blue lock levers (1) toward the rear of the printer and open the LED holder (2).
3. Lift and remove the image drum cartridge (3). To protect the image drum cartridge, please
place it back in the styrofoam shipping package.
4. Squeeze the LED head (4) and the LED holder together to ease the tension on the springs (5).
Use a screwdriver to remove the two clamps (6) from the claws of the LED head. The claws are
located on the top and bottom of the left and right sides of the holder.
5. Gradually remove the LED head, being careful to keep the springs in place.
NOTE:
LED Head Replacement
After replacing the LED head, set the LED head drive time as described in Section 3.3 of this
Service Handbook.
{ }