OKIDATA OF2200, Руководство по обслуживанию

Страница: 169 / 410

18 Verification Stamp Enables (ON) or disables (OFF) printing a
circular mark near the bottom of the page
when an MCF RTP or PIP is received in
response to a page being sent. A printed
stamp indicates successful TX. NOTE: If
Verification Stamp (Technical Function 18) is
set to ON Technical Function 15 - MEMORY
transmit will be disabled. To perform a
MEMORY (Quick Scan) transmission while
Verification Stamp is ON load the document
press SELECT FUNCTION then press One
Touch Key 01. This will allow a one time
memory transmit session. OFF
19 Page Re-transmission Enables (ON) or disables (OFF) page
retransmission from memory if a
communications error exists in non-ECM
mode. ON
20 Communication Error
Redial Enables (ON) or disables (OFF) redialing
when memory transmission fails. ON
21 Closed Network
Reception The lower four digits of the TSI/CSI (from the
remote station) are compared with the
registered one touch and auto dial numbers of
the local station. If the numbers do not match
the communication will disconnect. OFF
22 Relay Station Okifax
2600 ONLY Enables (ON) or disables (OFF) the relay key
station function. OFF
23 Print Relay Message
Okifax 2600 ONLY Enables (ON) or disables (OFF) printing the
relay message when the fax handled the
message as a relay station. This function is
available ONLY on the Okifax 2600. OFF
24 Relay Key Word Okifax
2600 ONLY Sets the relay key word four digit password for
relay operation for relay transmission. 0000
25 Print Forward Message Enables (ON) or disables (OFF) printing the
forward message when the forward message
communication is completed. OFF
26 No Paper Reception Enables (ON) or disables (OFF) storing
received messages in memory when the
reception mode (One Touch Key 21) is
selected as print mode. ON
ON: RX messages are stored in memory
when the following occur: No Paper Cover
Open Paper Jam.
OFF: Messages are not stored.