Oki proColor pro900DP, Руководство пользователя

Страница: 10 / 18

______________________________________________________________________________________
Pro900DP Set-Up and Print Overview
9
1.6
Jog Testing
Note: For this step, the feeder should be in the Powered-On /
Ready state.
- With the 2” pre-shingled stack of media in place, hit the jog button
repeatedly to feed several pieces of media through the gate –
observing the overlap and positioning of the media.
- If sheets are overlapping (bottom sheet is not completely separated
from the sheet on top of it, when exiting the gate) or double feeds are
occurring, lower the gate adjustment by approximately 1/8 to 1/4 turn.
- If double feeds continue, move the wedge forward slightly.
- Check for skewing, jamming or any damage to the media. Damage or
pinching of media can result if gate is lowered too much, or from the
wedge being set too far forward.
- Adjust the side guides in the discharge area so that there is a slight
gap (1/8-1/4”) between each side of the media and the guide rails.
There should be no binding of the media and the guide rails.
- If feeding problems persist, refer to Troubleshooting section of this
guide, or the Feeder/Conveyor Product Guide.