Oki OKIOFFICE 1200, Руководство по полевой инженерии, Страница: 105 / 207

3-78
3.19 Set Service Code
This is the code which, one can protect the life monitor clear operation. If it is not necessary to protect to
the life monitor clear operation, abort this operation without entering the service code.
1. Press Program key, *, J (10).
Set Service Code
Old Passcode :****
2. Your next mode depends on whether you’re creating or modifying the service code:
•
If creating --- Use the numeric keypad to enter 0000 and press ENTER .
•
If modifying --- Use the numeric keypad to enter the proper service code and press ENTER. If you
enter an invalid code, the fax will reject the attempt and abort this operation.
3. Use the numeric keypad to enter the four-digit service code.
Set Service Code
New Passcode :1234
4. Press ENTER.
Note: To turn off the service code and return to normal life monitor clear (not protect), change the code to
0000 by repeating steps 1-4 and entering 0000 in step 3.
3.20 Life monitor maintenance
When you replace the main control PCB, you should register the previous several counter values of the
life monitor.
1. Before updating the software or replacing the main control PCB, you must write down the counter
values of the life monitor.
2. To confirm the life monitor, press Program key, *, 9, ENTER. Then press one-touch key G to P. (See
“3.10.1 Life Monitor,” page 3-64.)
3. After you write down the counter values of the life monitor, update the software or replace the main
control PCB.
4. Then, press Program key, *, K(11).
Drum Replaced Count
0000000000
5. Enter previous value of the number of drum replaced time, then press ENTER.
Drum Life
0000000000
6. Enter previous value of the total pages printed on current drum, then press ENTER.
Toner Replaced Count
0000000000
7. Enter previous value of the toner replaced count, then press ENTER.
Toner Life
0000000000
8. Enter previous value of the toner life, then press ENTER.
Fuser Replaced Count
0000000000