OKILAN 6020E PLUS INSTALLATION GUIDE
INSTALLING THE PRINT SERVER
3
.
NOTE
Some countries may require a different adapter for local voltages,
such as 240 VAC.
5.
Attach the 10/100Base-T UTP cable to the receptacle on the
back of the print server.
6.
Attach the other end of the cable to the network.
P
OWERING
O
N
THE
P
RINT
S
ERVER
Switch your printer power on. The print server runs through a set of
power-up diagnostics for a few seconds. If the print server is
operating properly, the green 100 Base-T light (
1
) blinks
momentarily and then goes out (refer to the next page for light
status descriptions). If the green light blinks continuously in a
regular pattern, there is a problem. If this is the case, first verify
that you have a good Ethernet connection, and then try turning the
unit off and then on again. If the problem persists, refer to the
Troubleshooting section on page 12 in this Guide. When the green
