Oki OKIFAX OF5900, Руководство по обслуживанию

Страница: 457 / 472

OKIFAX 5700/5900 G - 8
3.3 G4 Board PC Loading Procedure
3.3.1 Explanation of Procedure
The G4 board PC loading procedure is explained below assuming that the MFP system is
normal.
1. With the host PC connected to the MFP (having a G4 board) through a Centro cable, turn
on the PC and then MFP.
2. Start MS(PC)-DOS on the PC, then perform the G4 board PC loading start key operation on
the MFP. (Make sure “PC-LOADING” is displayed on the LCD on the MFP system and the
“Ready” buzzer sounds.)
3. Execute an MS(PC)-DOS command “COPY” along with a binary switch on the PC to output
the G4 board PC loading data file to the LPT1. Thus, the loading data can be transferred to
the MFP.
Example: >copy/b xxx.x LPT1 (xxx.x is a loading file name.)
4. Look at the message on the LCD and listen to the “MFP normal end” buzzer to check that
G4 board PC loading has been competed normally. If the MFP displays an error code on
the LCD, issues an error buzzer, or turns on an alarm LED, power the MFP off and on again
to perform the above steps again assuming that a PC loading error has occurred.
Caution!
Even if a G4 board memory error or a G4 board flash memory contents error occurs to-
gether with a hash match error (i.e., runaway), G4 board loading can be performed follow-
ing the procedure mentioned above.
(For more details, refer to the “FX056/176 System Specifications; G4 Initial.”)