42114101 Rev.1
66 /
3.3.9 Carriage Cable
(1)
Remove the printhead (see 3.3.1).
(2)
Remove the upper cover (see 3.3.4 (1) – (5)).
(3)
Remove the gear case Assy (see 3.3.5).
(4)
Remove the space motor (see 3.3.7).
(5)
Remove the space rack (3.3.8).
(6)
Remove two screws
1
, release the Control Board
2
and PCB sheet
9
by lifting clamp
8
, and disconnect cable from connector
3
,
4
,
5
,
6
.
(7)
Remove carriage cable
7
from fasteners on frame.
(8)
To install, follow the removal steps in the reverse order.
Note on installation:
(1)
Take care not to fold the carriage cable
7
during installation. Curve slightly the
carriage cable
7
when assembling into the fasteners.
(2)
Make sure that the paper end lever
A
will not contact the Paper end Sensor
0
when
mounting the Control Board.
(3)
Make sure that there is not any dust or oil on the connector contact sections A to
D. If it is found, wipe it off by alcohol.
0
A
7
2
Claw
Claw
A
B
C
D
7
8
6
3
4
9
2
5
1
4
Содержание ML490 Series
