Oki C9800hdn, Руководство по настройке, Страница: 51 / 168

3
3-7 About Setup
About Setup
Setup configures the Fiery to communicate with other devices and manage print jobs.
You must perform Setup the first time you turn on the Fiery, or if the internal hard
disk drive has just been replaced. An initial Setup using default settings is adequate for
allowing users to print to the Fiery and use the WebTools. When your network or user
printing environment changes, you can change Setup options accordingly.
The first time you perform Setup, you must use the printer’s Control Panel.
Configure, at a minimum, Server Setup, Network Setup, and Printer Setup, in that
sequence. After the initial Setup, you can change Setup options from the printer’s
Control Panel (
page 4-2 ) or Command WorkStation. Most Setup options can be set
using any of these methods.
If you do not configure the remaining Setups, the Fiery uses default settings. You need
to make settings appropriate for the printing environment at your site.
Network server setup requirements
For Novell and Windows NT 4.0/2000/Server 2003 (using TCP/IP) networks, you
must configure the network servers for printing to the Fiery
before you configure Fiery
network settings in Setup. For chapter references to information about network server
Setup, see the diagrams in
Chapter 1 .
Use these settings
in Setup
1
(Minimum)
2 3 4 5
(Maximum)
Enable Direct connection
✔ ✔ ✔
Enable Print queue
✔ ✔ ✔ ✔
Enable Web Services
✔ ✔ ✔
Set an Administrator Password
(
strongly recommended )
✔ ✔ ✔ ✔
Set an Operator password
✔ ✔ ✔