Okamura CP, Инструкция по эксплуатации

Страница: 12 / 21

22 21
Parts Replacement
Attaching the adjustable armrests Attaching the garment hanger
Attaching the headrest
Attaching the lumbar unit
Remove the armless caps using a flathead screwdriver, etc.
Fix the arms from the side using the supplied bolts (one
bolt per side).(Tool required: 6 mm hexagonal wrench)
Make sure the attached parts do not rattle.
1
2
3
Screw plate
Rear top of
the backrest frame
Hanger
attachment plate
Hanger unit
Name
plate
For low-back and high-back chairs
Remove the name plate on the top of the backrest frame
using a flathead screwdriver, etc.
Adjust the height of installation (4 levels) using the grooves
on the left and right of the hanger unit. As a guide, install at
the lowest level for a low-back chair and the highest level
for a high-back chair. Take extra care when setting the
height of installation so as not to get your jacket caught
between the floor and the casters when the seat is reclined.
Position the hanger unit between the hanger attachment
plate and the screw plate, and secure the hanger using the
two screws provided. Attach the name plate on the hanger
attachment plate.
Make sure the parts do not rattle.
1
2
3
Hanger
attachment plate
Hanger unit
Headrest
Name
plate
For extra-high back chairs
Remove the name plate from the headrest using a flathead
screwdriver, etc. Remove the two screws used to secure
the headrest.
Adjust the height of installation (4 levels) using the grooves
on the left and right of the hanger unit. As a guide, install at
the lowest level for a low-back chair and the highest level
for a high-back chair. Take extra care when setting the
height of installation so as not to get your jacket caught
between the floor and the casters when the seat is reclined.
Position the hanger unit between the hanger attachment
plate and the screw plate, and secure the hanger using the
two screws which were removed in step 1. Attach the
name plate on the hanger attachment plate.
Make sure the parts do not rattle.
* Do not use the screw plate and screws provided for extra
high back type.
Remove the name plate on the rear top of the backrest
frame using a flathead screwdriver, etc.
Insert the headrest from above into the top of the backrest
frame while aligning it with the three holes. Make sure it is
fully inserted.
Fit the supplied screw plate into the holes at the rear top of
the backrest frame, then secure the headrest with the two
screws provided. Attach the name plate on the headrest.
Make sure the parts do not rattle.
From the back of the chair, fit the lumbar unit between the
left and right frames while bending it inwards.
Insert the four clips of the lumbar unit into the grooves on
the inside of the backrest frame. Use the installation guide
lines to determine the installation position.
GB
1
2
3
1
2
1
2
3
4
1
2
3
4
1
2
3
4
2
1
Armless cap
Installation
guide lines
1
2
3
Screw plate
Rear top of
the backrest frame
Name plate
Headrest