OJ Electronics WLM2-1BA, Руководство пользователя

Страница: 6 / 32

6
TROUbLE SHOOTING
- If any LED is flashing on master - Please refer to section “Error indication”.
Room is too cold.
(After running for at least 48 hours)
Room is too hot.
(After running for at least 48 hours)
The room sensor is placed in a position that does not represent the general temperature in the
room. E.g. mounted on external wall or near an extraneous heat source
If the room is controlled by a WLCT2 room controller, check that the time and temperatures are
set correctly.
If the room sensor has got an override switch (WLTM or WLTD), the switch may be set in the “off”
or “night” position.
For rooms with floor sensors, the maximum floor limit setting could be preventing the room
reaching the desired temperature.
Insufficient heating capacity of the system.
bad insulation creating large heat loss.
This could be caused by draughts within the wall cavities.
The room sensor is placed in a position that does not represent the general temperature in the
room.
If the room is controlled by a WLCT2 room sensor, check that the time and temperatures are set
correctly.
If the room sensor has got an override switch (WLTM or WLTD), the switch may be set in the “day”
position
For rooms with floor sensors, the minimum floor limit setting could be increasing the room
temperature above the desired setting.
Solar gain or extraneous heat source.
1
2
3
4
5
6
1
2
3
4
5
6
Q
ui
CK
gui
DE
s