34
NOTE! When you enter a locking code
when changing the default, the code
will not be required again until the unit
has been untouched for 10 minutes,
when the display goes into idle state.
You can also set the display in idle
state by pressing the ESC button for a
long period of time.
8.4 Display settings
8.5 Type information
Type information shows the hardware and software versions. This in-
formation is useful especially in case of maintenance or upgrade.
System settings > Display settings
System settings > Type information
Display settings
Display version xxxxx
Contrast 75 >
External display In use >
Type information
Contrast:
You can adjust the contrast of the display. If you wish the
display to be brighter, set a smaller numerical value. The setting range
is 50… 100. New setting is taken in use after confirmation is done.
External display:
The external display is connected to the RJ45-II
port. Use e.g. a CAT-5 cable up to 20 m
8.6 Lock code
If you have taken lock code into use, you may change the code. The
factory setting of lock code is 0000.
System settings > Lock code
System settings > Change lock code
1. S203 device asks you to enter the current code. The factory set-
ting of lock code is 0000.
2. Turn the control knob and press OK to accept each number.
Press ESC to return to the previous square.
3. Press OK for a number of seconds to accept the code.
Press ESC for a number of seconds to cancel.
System settings
Network settings >
Display settings >
Type info >
Lock code Not in use >
Lock code
In use
Not in use
Give lock code
0 0 0
0
Approve: Press OK for a number of seconds
Cancel: Press ESC for a number of seconds
When lock code is taken in use, it’s not possibel to change any set-
tings without entering lock code. It is recommended that you take lock
code into use if the device is located so that anyone could reach it
and change settings (e.g. deactivate burglar monitoring). Locking the
device and changing the lock code prevents unauthorized use of the
device.
TYPE INFORMATION
Send message: Type information.
The reply message will show informa-
tion about the device and software.
Lock code function
Description
Not in use
You can read S203 device information and change settings.
In use
You can read S203 device information but you can not change settings
without entering the lock code. The factory setting of lock code is 0000. If
you take lock code into use, change the code for security reasons.
RJ45-2
S203
Serial number xxxxxxx
S203 2.1.1
Ouman Ouflex
4.1.5 2MB
Display
4.1.5 2MB
Platform SW 4.1.5
