EN 6 Ranger
™
4000 Count Series
The colored LED indicators on the left side of the control panel are used in Checkweigh mode
(section 3.7) and will light up according to the following rules:
(Red) Loads > Upper limit
(Green) L
oads ≥ Lower limit and ≤ Upper limit
(Yellow) Loads < Lower limit
Figure 3-3. Below view of Ranger Count 4000
3.2 Turning Scale On/Off
To turn the scale on, press and hold the
On/Zero Off
button for 1 second. The scale performs a
display test, momentarily displays the software version, and then enters the active weighing
mode.
To turn the scale off, press and hold the
On/Zero Off
button until OFF is displayed.
3.3 Counting
Ranger Count 4000 has three display areas. Weight, Piece Weight and Count information are
displayed in these areas respectively.
3.3.1 Preset tare
Enter a value with the numeric keypad. The value will be displayed in the Count window.
Pressing Tare key, the value in current unit will then be saved as the preset tare.
To clear the tare value, clear the pan and press
Tare
key.
3.3.2 APW Establishment
If there is no APW established, both the piece weight display and the count display will show 0.
Power Input
Weigh Below
Access
Lock Switch
RS232 and Option
Interface Port
(below cover)
Battery
Chamber
