OHAUS Ranger R21PE15, Инструкция по эксплуатации

Страница: 20 / 44

EN-18
Ranger™ 2000
Series
4.4 Setup Menu
Enter this menu to set scale parameters.
Reset [
reset
]
Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Power on unit [
pwWr.UN
]
Set the unit of measure displayed at startup.
auto = last unit in use when turned off
kg = kilograms
g = grams
lb = pounds
oz = ounces
lb:oz = pound ounces
Zero Range [
ZErO
]
Set the percentage of scale capacity that may be zeroed.
2% = zero up to 2 percent of capacity
10% = zero up to 10 percent of capacity
Auto Tare [
A.tArE
]
Set the automatic tare functionality.
OFF = Automatic Tare is disabled
ON = the first stable gross weight is tared.
ON-ACC = stable gross loads within the accept limits are tared (in Check
weighing mode).
Beeper Signal [
Bp.sIG
]
Set how the beeper responds in Check Weighing mode.
OFF = the beeper is disabled
ACCEPT = the beeper will sound when the weight is within the Accept range.
UNDER = the beeper will sound when the weight is below the Under setting.
OVER = the beeper will sound when the weight is above the Over setting.
UNDER-
OVER = the beeper will sound when the weight is below the Under setting
or above the Over setting.
Reset: no , yes
Power on unit: auto , kg, g, lb, oz, lb:oz
Zero Range: 2%, 10%
Beeper Signal: off , accept, under, over, under-over
Beeper Key: off , on
Accumulation: off , auto, manual
End Setup: Exit menu