OHAUS Courier 1000, Инструкция по эксплуатации

Страница: 9 / 17

Courier 1000 EN-5
3. OPERATION
3.1 Turning On/Off the Scale
To turn the scale on, short press the ON/ZERO Off button. The scale performs a display test, momentarily
displays the model/software version, and then enters the weighing mode.
To turn the scale off, long press ON/ZERO Off button until OFF is displayed.
3.2 Zero Operation
By short pressing the ON/ZERO Off button, the scale display returns to zero. When adding additional mass, the
ON/ZERO Off button may be used repeatedly until the full capacity of the scale is reached. When a container is
used, the ON/ZERO Off button may be used to initiate Tare function. Additional mass may then be added as a
NET weight. When removing both the sample and container from the scale, a negative value may be displayed.
Zero the scale again before subsequent usage.
NOTE : The ON/ZERO Off button will perform a true zero setting function when displayed values are 2%
of full capacity. Above 2%, the range is limited to full capacity by subtraction.
3.3 Changing the Units of Measure
Short press the UNITS Cal button to display the next available measuring unit.
3.4 Auto Shut-Off
To extend battery life, the scale will automatically turn off after approximately four minutes of inactivity. This
feature is only active during battery operation.
3.5 Dynamic Weighing
With the platform empty, short press the UNITS Cal button to cycle
through the units. Dynamic mode is active when the symbol " • “is
flashing.
Place an item on the platform. The scale will show “-A-”.
NOTE : If using a container, press ON/ZERO Off to tare the weight and
return to zero.
With an item or a container on the platform, a short press of UNITS Cal
will start the averaging countdown from 5 seconds.
The average weight is then displayed. The terminal • stops flashing
when the process is complete.
The display will hold until a button is pressed.
To repeat the process, press UNITS Cal with an item or a container on
the platform.
To Exit, remove all weight from the platform or container and short
press UNITS Cal button.
3.6 Weight Alert TM
With platform empty, press the UNITS Cal button until the lb unit displayed.
The digits will start to flash if the weight on the platform is over 70 lb.
If the weight on the pan is over 150 lb, the digits will stop flashing.
NOTE : Weigh Alert
TM
is only available on i-C12P75 model. Weight Alert
TM
is available only in lb mode without
Dynamic Weighing. Make sure that the "lb" is turned On and the "•" dynamic weighing is turned Off.