OHAUS Aviator 7000 Series, Руководство по обслуживанию

Страница: 46 / 50

Service Manual
Page 46 of 50
\____/ \__________________/ \____________/
Setting number Basic price text
(04) 6 digits 13 chars
Setting number 05
: Basic Price, Tare value, Text
EOT STX 30h 35h ESC D5 D4 D3 D2 D1 D0 ESC T3 T2 T1 T0 ESC A................A ETX
\___/ \__________________/ \__________/ \_____ _____/
setting number Basic price tare value text
(05) 6 digits 4 digits 13 chars
Setting number 08
: Status information Request
EOT STX 30h 38h ETX
\_/
Setting number
(08)
Scale data reading
EOT ENQ
Scale Communications to a POS System
Setting number 02
: Weight, Price, and Total Price
STX 30h 32h ESC X ESC D4 D3 D2 D1 D0 ESC D5 D4 D3 D2 D1 D0 ESC D5 D4 D3 D2 D1 D0 ETX
\____/ I \_____________/ \________________/ \________________/
setting no. I scale - weight Basic price Price to pay
(02) status 5 digits 6 digits 6 digits
30H = lb
31H = lb. / 0,01
32H = lb. / 0,005
33H = kg
Setting number 09
: Status information
STX 30h 39h ESC S1 S0 ETX
\____/ \___/
setting no. Status
(09) I
I
Status: ASCII code 2 bytes
00 there is no error
01 general errors in the scale
02 parity error or more symbols that are permitted
10 invalid setting no.
11 invalid basic price
12 invalid tare value received
13 invalid text received
20 scale is still in motion (no standstill)
21
scale wasn’t in motion since las
t operation
22 there is still no price calculation
30 weight is less than minimum weight
31 scale is less than 0
32 scale is overloaded
6.1.7 NCI POS
6.1.7.1 OVERVIEW
The serial communications protocol is used to interface Weigh-Tronix/NCI POS (Point-of-Sale) scales to
ECR (Electronic Cash Registers), or other computing equipment (eg. personal computers).
Baud rate and parity will be configurable. Start and stop bits will each be fixed at one (1). Data bits will be
fixed at seven. Baud rates supported will be 1200, 2400, 4800, 9600 and 19200.Responses to serial
commands will be immediate, or within one weight meter cycle of the scale. One second should be more
than adequate for use as a time-out value by the remote (controlling) device.
There are two types of serial commands:
mandatory
and
optional
. Mandatory commands must be
supported by all products.
If weight is negative, in motion, over capacity or under capacity, or if a zero error exists, only the scale's
status is returned in response to a weight ('
W
') command.