OHAUS AV114C, Руководство по обслуживанию

Страница: 59 / 108

3-35
CHAPTER 3 REPAIR PROCEDURES
3.2.14 Installing the Ratio Beam (Cont.)
3. Refer to Figure 3-59 and check and clean the Magnet area. To clean, use a small wooden
stick with double-sided tape to remove any debris.
Figure 3-59. Load Cell Magnet Area.
Magnet Area
4. Refer to Figure 3-56 and replace the Aluminum Sleeves.
5. Refer to figure 3-60 and inspect the slotted area on the Ratio Beam and clean if necessary.
Slotted Area
Figure 3-60. Ratio Beam Vane Slotted Area.
Vane
6. Refer to Figure 3-55 and carefully place the Ratio Beam into postion in the Load Cell.
7. Refer to Figure 3-52 and replace the Aluminum Sleeves.
8. Carefully slide the InCal Weight Arm into position, see Figure 3-50.
9. Do not use tools in this step. Install the screws, washers and nuts for the Ratio Beam Arm
and the InCal Weight Arm.