1. Push the safety bar release lever down to release
To prevent clogging during chipping operations:
the feed roller safety bar.
1. Begin chipping operations only when the engine
is running at full throttle.
2. The rotor clutch lever must be all the way in
the ON position and not half way.
3. Check the belt tension on the rotor and ensure
the power is transmitted to the rotor
sufficiently.
4. When leaves and wood etc are wet they are
not chipped efficiently and are more likely to
2. Return the feed roller safety bar to its original
clog the machine.
position, pulled in the direction toward the
operator. At this moment, the feed roller must
not start yet.
3. Switch the feed switch to the safety bar release
After reading and understanding all the
position and then return the feed switch to start to
instructions in this "How to Operate Machine"
check that the feed roller starts again.
section you may commence chipping operations.
Note
Maximum diameter of infeed materials allowed is
7 cm for soft wood.
Do not remove, jam, disable, bypass, override or
otherwise impede the effectiveness of the feed
roller safety bar.
Do not position the hopper in higher or lower
positions such that the effectiveness of the safety
bar is compromised.
CAUTION 2
CAUTION 1
DISENGAGE FEED ROLLER SAFETY BAR
FEED ROLLER CLOGGING PREVENTION
START CHIPPING WORK OPERATIONS
SAFETY BAR RELEASE LEVER
PUSH
SAFETY BAR RELEASE POSITION
Feed Switch
STOP
START
- 21 -